References
- Jain P. K. On the way up: manganese, chrome ore, and ferro-alloy in India. Mineral Economics. 2020;33(3):275–283. doi:https://doi.org/10.1007/s13563-019-00174-7
- Lu L, Holmes RJ, Manuel RJ. Effects of alumina on sintering performance of hematite iron ores. ISIJ Int. 2007;47(3):349–358. doi:https://doi.org/10.2355/isijinternational.47.349
- Nyembwe MA. Study of sinter reactions when fine iron ore is replaced with coarse ore using an infrared furnace and sinter pot tests [dissertation (MSc)]. University of Pretoria; 2012 [cited 2019 Feb 12]. Available from: http://hdl.handle.net/2263/25837.
- Sasaki M, Hida Y. Consideration on the properties of sinter from the point of sintering reaction. Iron Steel. 1982;68(6):563–571. doi:https://doi.org/10.2355/tetsutohagane1955.68.6_56
- Scarlett NVY, Pownceby MI, Madsen IC, et al. Reaction sequences in the formation of silico-ferrites of calcium and aluminum in iron ore sinter. Metall Mater Trans. 2004;35:929–936. doi:https://doi.org/10.1007/s11663-004-0087-4
- Mezibricky R, Frohlichova M. Silico-ferrite of calcium and aluminum characterization by crystal morphology in iron Ore sinter microstructure. ISIJ Int. 2016;56(6):1111–1113. doi:https://doi.org/10.2355/isijinternational.ISIJINT-2016-044
- Matsuno F, Nishikida S, Ikesaki H. Disintegration of synthesized iron oxides by reduction at 550°C in 30%CO-N2 gas stream. ISIJ Int. 1984;24:1040–1049.
- Oluwadare GO. Roles of alumina and magnesia on the formation of SFCA in iron ore sinters. Trends Appl Sci Res. 2007;2:483–491. doi:https://doi.org/10.3923/tasr.2007.483.491
- Webster NAS, O’Dea DP, Ben Ellis G, et al. Effects of gibbsite, kaolinite and Al-rich goethite as alumina sources on silico-ferrite of calcium and aluminium (SFCA) and SFCA-I iron ore sinter bonding phase formation. ISIJ Int. 2017;57(1):41–47. doi:https://doi.org/10.2355/isijinternational.ISIJINT-2016-332
- Bristow NJ, Loo CE. Sintering properties of iron ore mixes containing titanium. ISIJ Int. 1992;32(7):819–828. doi:https://doi.org/10.2355/isijinternational.32.819
- Mezibricky R, Frochlichova M, Findorak R. Ore assimilation and secondary phases by sintering of rich and high-gangue iron ores. Minerals. 2019;9:128. doi:https://doi.org/10.3390/min9020128
- Zhu D, Xue Y, Pan J, et al. An investigation into aluminum occurrence impact on SFCA formation and sinter matrix strength. J Mater Res Technol. 2020;9(5):10223–10234. doi:https://doi.org/10.1016/j.jmrt.2020.07.032
- Sinha M, Ramna RV. Effect of Variation of alumina on the microhardness of iron ore sinter phases. ISIJ Int. 2009;49(5):719–721. doi:https://doi.org/10.2355/isijinternational.49.719
- Sinha M, Nistala SH, Chandra S, et al. Correlating mechanical properties of sinter phases with their chemistry and its effect on sinter quality. Ironmak Steelmak. 2016;44(2):100–107. doi:https://doi.org/10.1080/03019233.2016.1226004
- Gan M, Fan X, Chen X. Calcium ferrie generation during iron ore sintering crystallization behavior and influencing factors. Adv Topic Crystal Tech. 2015;301:301–320. doi:https://doi.org/10.5772/59659
- Umadevi T, Sah R, Mahapatra PC. Influence of sinter basicity (CaO/SiO2) on low and high alumina iron ore sinter quality. Min Proc Extractive Metall. 2014;123:75–85. doi:https://doi.org/10.1179/1743285514Y.0000000052
- Zhang M, Andrade MW. Effect of MgO and basicity on microstructure and metallurgical properties of iron ore sinter characterization. Miner Metal Mater. 2016;68:167–174. doi:https://doi.org/10.1007/978-3-319-48210-1_20
- Kashiwaya Y. Crystal phases formed in a CaO-Fe2O3 system under a high cooling rate in air. Miner Metal Mater Soc ASM Int. 2017;48(6):3228–3238. doi:https://doi.org/10.1007/s11663-017-1094-6
- Fernández-González D, Ruiz-Bustinza I, Mochón J, et al. Iron ore sintering: raw materials and granulation. Miner Process Extr Metall Rev. 2016;38(1):36–46. doi:https://doi.org/10.1080/08827508.2016.1244059
- Yang CC, qing Zh D, Shi BJ. Comparison of sintering performance of typical specular hematite ores with distinct size distributions. J Iron Steel Res Int. 2017;24:1007–1015. doi:https://doi.org/10.1016/S1006-706X(17)30147-4
- IS 6495:2003. Method of tumbler test for iron oxides: lump ores, sinter and pellets. Available from: http://www.bis.org.in.
- IS 10823:1994. Methods for determination of thermal degradation index (TDI) and reduction degradation index (RDI) of iron oxides, lump ores, sinter and pellets. Available from: http://www.bis.org.in.
- Zhai X, Wu S, Zhou H, et al. Flow and penetration behaviours of liquid phase on iron ore substrate and their effects on bonding strength of sinter. Ironmak Steelmak. 2020;47(4):405–416. doi:https://doi.org/10.1080/03019233.2018.1537223
- Andrews L, Loo CE, Evans G. Fundamental forces driving analogue sinter mix reshaping. ISIJ Int. 2016;56(7):1171–1180. doi:https://doi.org/10.2355/isijinternational.ISIJINT-2016-069
- Luz AP, Ribeiro S, Domiciano VG, et al. Slag melting temperature and contact angle on high carbon containing refractory substrates. Ceramica. 2011;57:342. doi:https://doi.org/10.1590/S0366-69132011000200003
- Umadevi T, Karthik P, Mahapatra P, et al. Optimization of FeO in iron ore sinter at JSW steel limited. Ironmak Steelmak. 2012;39(3):180–189. doi:https://doi.org/10.1179/1743281211Y.0000000080
- Pimenta HP, Seshadri V. Characterization of structure of iron ore sinter and its behavior during reduction at low temperatures. Ironmak Steelmak. 2002;29(3):503–511. doi:https://doi.org/10.1179/030192302225002009
- Shigaki I, Sawada M, Gennai N. Increase in low-temperature reduction degradation of iron ore sinter due to hematite-alumina solid solution and columnar calcium ferrite. Trans ISIJ. 1986;26:503–511. doi:https://doi.org/10.2355/isijinternational1966.26.503
- Hsieh LH. Effect of raw material composition on the sintering properties. ISIJ Int. 2005;45:551–559. doi:https://doi.org/10.2355/isijinternational.45.551
- Gan M, Fan X, Ji Z, et al. High temperature mineralization behavior of mixtures during iron ore sintering and optimizing methods. ISIJ Int. 2015;55(4):742–750. doi:https://doi.org/10.2355/isijinternational.55.742
- Kumar CU, Ramana RV, Ali S, et al. Quality of sinter in the light of blast furnace performance. Tata Search. 1995;1:37–42.