References
- Lee, N. H.; Hayashi, K. Effect of End-Covering and Low Pressure Steam Explosion Treatment on Drying Rate and Checking during Radio-Frequency/Vacuum Drying of Japanese Cedar Log Cross Sections. For. Prod. J. 2000, 50, 73–78.
- Kang, W.; Lee, N. H. Relationship between Radial Variations in Shrinkage and Drying Defects of Tree Disks. J. Wood Sci. 2004, 50, 209–216. DOI: https://doi.org/10.1007/s10086-003-0559-1.
- Fu, Z.; Cai, Y.; Zhao, J.; Huan, S. The Effect of Shrinkage Anisotropy on Tangential Rheological Properties of Asian White Birch Disks. BioResources 2013, 8, 5235–5243. DOI: https://doi.org/10.15376/biores.8.4.5235-5243.
- Fu, Z.; Zhao, J.; Yang, Y.; Cai, Y. Variation of Drying Strains between Tangential and Radial Directions in Asian White Birch. Forests 2016, 7, 59. DOI: https://doi.org/10.3390/f7030059.
- Kubler, H. Drying Tree Disks Simply and without Defects. For. Prod. J. 1974, 24, 33–35.
- Kubler, H. Study on Drying of Tree Cross Sections. Wood Sci. 1975, 7, 173–181.
- Kubler, H. Formation of Checks in Tree Stems during Drying. For. Prod. J. 1977, 27, 41–46.
- Hsu, N. N.; Tang, R. C. Internal Stresses of Wood Logs Due to Anisotropic Shrinkage. Wood Sci. 1974, 7, 43–51.
- Kang, W.; Lee, N. H. Mathematical Modeling to Predict Drying Deformation and Stress Due to the Differential Shrinkage within a Tree Disk. Wood Sci. Technol. 2002, 36, 463–476. DOI: https://doi.org/10.1007/s00226-002-0153-5.
- Lee, N. H.; Hayashi, K.; Jung, H. S. Effect of Radio-Frequency/Vacuum Drying and Mechanical Press-Drying on Shrinkage and Checking of Walnut Log Cross Sections. For. Prod. J. 1998, 48, 73–79.
- Lee, N. H.; Li, C.; Choi, J. H.; Hwang, U. D. Comparison of Moisture Distribution along Radial Direction in a Log Cross Section of Heartwood and Mixed Sapwood and Heartwood during Radio-Frequency/Vacuum Drying. J. Wood Sci. 2004, 50, 484–489. DOI: https://doi.org/10.1007/s10086-003-0605-z.
- Fu, Z. Y.; Zhao, J. Y.; Lv, Y. Y.; Huan, S. Q.; Cai, Y. C. Stress Characteristics and Stress Reversal Mechanism of White Birch (Betula Platyphylla) Disks under Different Drying Conditions. Maderas-Cienc Technol. 2016, 18, 361–372.
- Fu, Z.; Zhao, J.; Huan, S.; Sun, X.; Cai, Y. The Variation of Tangential Rheological Properties Caused by Shrinkage Anisotropy and Moisture Content Gradient in White Birch Disks. Holzforschung 2015, 69, 573–579. DOI: https://doi.org/10.1515/hf-2014-0089.
- Li, C. Y.; Lee, N. H. Effect of External Compressive Load on Tangential Strain Behavior in Japanese Larch Log Cross Sections during Radio-Frequency/Vacuum Drying. J. Wood Sci. 2007, 53, 291–295. 2007, DOI: https://doi.org/10.1007/s10086-006-0869-1.
- Fu, Z.; Avramidis, S.; Weng, X.; Cai, Y.; Zhou, Y. Influence Mechanism of Radio Frequency Heating on Moisture Transfer and Drying Stress in Larch Boxed-Heart Square Timber. Dry. Technol. 2019, 37, 1625–1632. DOI: https://doi.org/10.1080/07373937.2018.1526191.
- Choi, J. H.; Lee, N. H. Effect of End-Taping and Removal of Sapwood on Radial Distribution of Moisture Content and Tangential Strains during Radio-Frequency/Vacuum Drying of Cedrela Sinsensis Log Cross Sections. J. Wood Sci. 2004, 50, 315–320. DOI: https://doi.org/10.1007/s10086-003-0577-z.
- Hu, X. Y.; Liu, Z. L.; Zhuang, Z. XFEM Study of Crack Propagation in Logs after Growth Stress Relaxation and Drying Stress Accumulation. Wood Sci. Technol. 2017, 51, 1447–1468. DOI: https://doi.org/10.1007/s00226-017-0943-4.
- Kowalski, S. J.; Smoczkiewicz-Wojciechowska, A. Stresses in Dried Wood. Modelling and Experimental Identification. Transp. Porous Med. 2007, 66, 145–158. DOI: https://doi.org/10.1007/s11242-006-9011-5.
- Richter, C. Wood Characteristics: Description, Causes, Prevention, Impact on Use and Technological Adaptation. Springer: Heidelberg, 2014.
- Anoop, E. V.; Jijeesh, C. M.; Jinu, S.; Vishnu, R.; Anish, M. C. Identification and Characterization of Tension Wood in Acacia Auriculiformis A. Cunn. ex Benth. and Acacia Mangium Willd. Grown in Kerala. In Wood is Good, Pandey, K., Ramakantha, V., Chauhan, S., Arun Kumar, A., Eds. Springer: Singapore, 2017; pp 153–159.
- Araman, P.; Winn, M.; Kabir, F.; Torcheux, X.; Loizeaud, G. Unsound Defect Volume in Hardwood Pallet Cants. For. Prod. J. 2003, 53, 45–49.
- Carpenter, R. D. Defects in Hardwood Timber (No. 678). US Department of Agriculture, Forest Service: Newtown Square, PA, 1989.
- Shortle, W. C.; Dudzik, K. R. Wood Decay in Living and Dead Trees: A Pictorial Overview. Gen. Tech. Rep. NRS-97. US Department of Agriculture, Forest Service, Northern Research Station: Newtown Square, PA, 2012, p 26.
- Avramidis, S.; Zwick, R. L. Commercial-Scale RF/V Drying of Softwood Lumber. Part 2. Drying Characteristics and Lumber Quality. For. Prod. J. 1996, 46, 27–36.
- Avramidis, S.; Zwick, R. L. Commercial-Scale RF/V Drying of Softwood Lumber. Part 3. Energy Consumption and Economics. For. Prod. J. 1997, 47, 48–56.
- Lee, N. H.; Luo, J. Y. Effect of Steam Explosion Treatments on Drying Rates and Moisture Distributions during Radio-Frequency/Vacuum Drying of Larch Pillar Combined with a Longitudinal Kerf. J. Wood Sci. 2002, 48, 270–276. DOI: https://doi.org/10.1007/BF00831346.
- Kang, W.; Lee, N. H.; Choi, J. H. A Radial Distribution of Moistures and Tangential Strains within a Larch Log Cross Section during Radio-Frequency/Vacuum Drying. Holz Als Roh-Und Werkstoff 2004, 62, 59–63. DOI: https://doi.org/10.1007/s00107-003-0432-3.
- Simpson, W. T. Dry Kiln Operator’s Manual; United States Department of Agriculture Forest Service Forest Products Laboratory: Madison, WI, 1991.
- Yamashita, K.; Hirakawa, Y.; Saito, S.; Nakatani, H.; Ikeda, M.; Ohta, M. Surface-Check Variation in Boxed-Heart Square Timber of Sugi (Cryptomeria Japonica) Cultivars Dried by the Conventional Kiln Drying. J. Wood Sci. 2012, 58, 259–266. DOI: https://doi.org/10.1007/s10086-011-1239-1.
- Jung, H. S.; Eom, C. D.; So, B. J. Comparison of Vacuum Drying Characteristics of Radiata Pine Timber Using Different Heating Methods. Dry. Technol. 2004, 22, 1005–1022. DOI: https://doi.org/10.1081/DRT-120038577.
- Harris, R. A.; Taras, M. A. Comparison of Moisture Content Distribution, Stress Distribution, and Shrinkage of Red Oak Lumber Dried by a Radio-Frequency/Vacuum Drying Process and a Conventional Kiln. For. Prod. J. 1984, 34, 44–54.
- Avramidis, S.; Liu, F. Drying Characteristics of Thick Lumber in a Laboratory Radio-Frequency/Vacuum Dryer. Dry. Technol. 1994, 12, 1963–1981. DOI: https://doi.org/10.1080/07373939408962215.
- Oltean, L.; Teischinger, A.; Hansmann, C. Influence of Temperature on Cracking and Mechanical Properties of Wood during Wood Drying–a Review. BioResources 2007, 2, 789–811.
- Xie, D.; Lee, N. H.; Chang, Y. S.; Yeo, H. Effect of Alternating Vacuum and Release Process on Drying Characteristics of Log Cross Section during Radio Frequency Drying. J. Korean Wood Sci. Technol. 2013, 41, 456–465. DOI: https://doi.org/10.5658/WOOD.2013.41.5.456.
- Vermaas, R. F. Interaction of Wood, Water and Stresses during Drying: A Review. South. Afr. For. J. 1988, 181, 25–32. DOI: https://doi.org/10.1080/10295925.1998.9631177.
- Tarmian, A.; Sepeher, A.; Rahimi, S. Drying Stress and Strain in Tension Wood: A Conventional Kiln Schedule to Efficiently Dry Mixed Tension/Normal Wood Boards in Poplar. Dry. Technol. 2009, 27, 1033–1040. DOI: https://doi.org/10.1080/07373930903218396.