Experimental Investigation Of Spray Cooling Heat Transfer On Straight Fin Surface Under Acceleration Conditions

References

• I.Mudawar and K. A.Estes, Optimizing and Predicting CHF in Spray Cooling of a Square Surface, J. Heat Transf., vol. 118, pp. 672–679, 1996.
   Web of Science ®Google Scholar
• L.Lin and R.Ponnappan, Heat Transfer Characteristics of Spray Cooling in a Closed Loop, Int. J. Heat Mass Transf., vol. 46, pp. 3737–3746, 2003.
   Web of Science ®Google Scholar
• E.Martinez-Galvan, J. C.Ramos, and R.Anton, Film Thickness and Heat Transfer Measurements in a Spray Cooling System with R134a, J. Electron. Packag., vol. 133, pp. 011002-1–11, 2011.
   Web of Science ®Google Scholar
• M.Visaria and I.Mudawar, Effects of High Subcooling on Two-Phase Spray Cooling and Critical Heat Flux, Int. J. Heat Mass Transf., vol. 51, pp. 5269–5278, 2008.
   Web of Science ®Google Scholar
• I.Mudawar, D.Bharathan, K.Kelly and S.Narumanchi. Two-Phase Spray Cooling of Hybrid Vehicle Electronics, IEEE Trans. Compon. Packag. Technol., vol. 32, pp. 501–512, 2009.
   Web of Science ®Google Scholar
• R. H.Chen, L. C.Chow, and J. E.Navedo, Effects of Spray Characteristics on Critical Heat Flux in Subcooled Water Spray Cooling, Int. J. Heat Mass Transf., vol. 45, pp. 4033–4043, 2002.
   Web of Science ®Google Scholar
• R. H.Chen, L. C.Chow, and J. E.Navedo, Optimal Spray Characteristics in Water Spray Cooling, Int. J. Heat Mass Transf., vol. 47, pp. 5095–5099, 2004.
   Web of Science ®Google Scholar
• M. R.Pais, E. T.Mahefkey, and L. C.Chow, Surface Roughness and Its Effect on the Heat Transfer Mechanism in Spray Cooling, J. Heat Transf., vol. 114, pp. 211–219, 1992.
   Web of Science ®Google Scholar
• R.Melser and G.Mailen, Nucleate Boiling in Thin Liquid Films, AIChE J., vol. 23, pp. 954–957, 1977.
   Web of Science ®Google Scholar
• J.Yang, L. C.Chow, and M. R.Pais, Nucleate Boiling Heat Transfer in Spray Cooling, J. Heat Transf., vol. 188, pp. 668–671, 1996.
   Web of Science ®Google Scholar
• D. P.Rini, R. H.Chen, and L. C.Chow, Bubble Behavior and Nucleate Boiling Heat Transfer in Saturated FC-72 Spray Cooling, J. Heat Transf., vol. 124, pp. 63–72, 2001.
   Web of Science ®Google Scholar
• L. C.Lin and R.Ponnappan, Critical Heat Flux of Multi-Nozzle Spray Cooling, J. Heat Transf., vol. 126, pp. 482–485, 2004.
   Web of Science ®Google Scholar
• A. G.Pautsch and T. A.Shedd, Adiabatic and Diabatic Measurements of the Liquid Film Thickness During Spray Cooling with FC-72, Int. J. Heat Mass Transf., vol. 49, pp. 2610–2618, 2006.
   Web of Science ®Google Scholar
• K.Oliphant, B. W.Webb, and M. Q.McQuay, An Experimental Comparison of Liquid Jet Array and Spray Impingement Cooling in the Nonboiling Regime, Exp. Therm. Fluid Sci., vol. 18, pp. 1–10, 1998.
   Web of Science ®Google Scholar
• J.Sigler and R.Mesler, The Behavior of the Gas Film Formed upon Drop Impact with a Liquid Surface, Int. J. Colloid Interface Sci., vol. 134, pp. 459–474, 1990.
   Web of Science ®Google Scholar
• J. R.Yang and S. C.Wong, Wong, On the Discrepancies Between Theoretical and Experimental Results for Microgravity Droplet Evaporation, Int. J. Heat Mass Transf., vol. 44, pp. 4433–4443, 2001.
   Web of Science ®Google Scholar
• J. R.Rybicki and I.Mudawar, Single-Phase and Two-Phase Cooling Characteristics of Upward Facing and Downward Facing Sprays, Int. J. Heat Mass Transf., vol. 49, pp. 5–16, 2006.
   Web of Science ®Google Scholar
• M. K.Sung and I.Mudawar, Single-Phase and Two-Phase Heat Transfer Characteristics of Low Temperature Hybrid Micro-Channel/Micro-Jet Impingement Cooling module, Int. J. Heat Mass Transf., vol. 51, pp. 3882–3895, 2008.
   Web of Science ®Google Scholar
• Y. Q.Wang, M. H.Liu, D.Liu, and K.Xu. Experimental Study on the effects of spray inclination on Water Spray Cooling Performance in Non-Boiling Regime, Exp. Therm. Fluid Sci., vol. 34, pp. 933–942, 2010.
   Web of Science ®Google Scholar
• E. A.Silk, J.Kim, and K.Kiger, Impact of Cubic Pin Finned Surface Structure Geometry upon Spray Cooling Heat Transfer, The American Society of Mechanical Engineers 2005 Heat Transfer Summer Conference, San Francisco, CA, pp. 17–22, July 2005.
   Google Scholar
• E. A. Silk, Investigation of Enhanced Surface Spray Cooling, Ph.D. Thesis, University of Maryland, Washington, DC, 2006.
   Google Scholar
• E. A.Silk, J.Kim, and K.Kiger, Spray Cooling of Enhanced Surfaces: Impact of Structured Surface Geometry and Spray Axis Inclination, Int. J. Heat Mass Transf., vol. 49, pp. 4910–4920, 2006.
   Web of Science ®Google Scholar
• L.Ortiz and J. E.Gonzalez, Experiments on Steady-State High Heat Fluxes Using Spray Cooling, Exp. Heat Transf., vol. 12, pp. 215–233, 1999.
   Web of Science ®Google Scholar
• J.Schwarzkopf, T.Cader, K.Okamoto, B. Q.Li, and B.Ramaprian, Effect of Spray Angle in Spray Cooling Thermal Management of Electronics, The American Society of Mechanical Engineers 2004 Heat Transfer & Fluids Engineering Summer Conference, Charlotte, NC, pp. 423–431, 11–15 July 2004.
   Google Scholar
• Y. X.Guo, Z. F.Zhou, J. Y.Jia, and S. R.Zhou, Optimal Heat Transfer Criterion and Inclination Angle Effects on Non-Boiling Regime Spray Cooling, Semiconductor Thermal Measurement and Management Symposium, 2009. SEMI-THERM 2009. 25th Annual IEEE, San Jose, CA, pp. 193–200, 15–19 March 2009.
   Google Scholar
• Y. M.Qiao and S.Chandra, Spray Cooling Enhancement by Addition of Surfactant, J. Heat Transf., vol. 120, pp. 92–98, 1998.
   Web of Science ®Google Scholar
• Z. B.Yan, K. C.Toh, F.Duan, T. N.Wong, K. F.Choo, P. K.Chan and Y. S.Chua, Experimental Study of Impingement Spray Cooling for High Power Devices, Appl. Therm. Eng., vol. 30, pp. 1225–1230, 2010.
   Web of Science ®Google Scholar
• K.Sone, K.Yoshida, T.Oka, YoshiyukiAbe, Y.Miri, and A.Nagashima, Spray Cooling Characteristics of Water and FC-72 under Reduced and Elevated Gravity for Space Application, IECEC 96., vol. 2, pp. 1500–1505, 1996.
   Google Scholar
• K.Yoshida, Y.Abe, T.Oka, Y. H.Mori, and A.Nagashima, Spray Cooling under Reduced Gravity Condition, J. Heat Transf., vol. 123, pp. 309–318, 2000.
   Web of Science ®Google Scholar
• A. G.Pautsch and T. A.Shedd, Spray Impingement Cooling with Single- and Multiple-Nozzle Arrays. Part I: Heat Transfer Data Using FC-72, Int. J. Heat Mass Transf., vol. 48, pp. 3167–3175, 2005.
   Web of Science ®Google Scholar
• Z.Zhang, P. X.Jiang, Y. T.Hu, and J.Li, Experimental Investigation of Continual- and Intermittent-Spray Cooling, Exp. Transf., vol. 26, pp. 453–469, 2013.
   Web of Science ®Google Scholar