REFERENCES
- Defaye , C. , Arghir , M. and Boneau , O. 2006 . “Experimental Study of the Radial and Tangential Forces in a Whirling Squeeze-Film Damper,” . Tribol. Trans. , 49 : 271 – 278 .
- Adiletta , G. and Pietra , L. D. 2006 . “Experimental Study of a Squeeze-film Damper with Eccentric Circular Orbits,” . J. Tribol. , 128 ( 2 ) : 365 – 377 .
- Warner , P. C. 1963 . “Static and Dynamic Properties of Partial Journal Bearings,” . J. Basic Eng. , 85 ( 2 ) : 247 – 257 .
- El-Shafei , A. 2003 . “Perturbation Solution for Finite Squeeze-Film Dampers Executing Linear Motion,” . Tribol. Lett. , 14 ( 2 ) : 111 – 121 .
- Taylor , D. L. and Kumar , B. R. K. 1980 . “Nonlinear Response of Short Squeeze-Film Dampers,” . J. Lubric. Tech. , 102 ( 1 ) : 51 – 58 .
- Gumbel , L. 1914 . Das Problem der Lagerreiburg, vol. 5, Monatsblatter Berliner Bezirksverein , 87 – 104 . 109 – 120 . VDI .
- Elrod , H. G. 1981 . “A Cavitation Algorithm,” . J. Lubric. Tech. , 103 ( 3 ) : 350 – 354 .
- Zeidan , F. Y. and Vance , J. M. 1989 . “Cavitation Leading to a Two Phase Fluid in a Squeeze-Film Damper,” . Tribol. Trans. , 32 ( 1 ) : 100 – 104 .
- Zeidan , F. Y. and Vance , J. M. 1990 . “Cavitation Regimes in Squeeze-Film Dampers and Their Effect on the Pressure Distribution,” . Tribol. Trans. , 33 ( 3 ) : 447 – 453 .
- Braun , M. J. and Henricks , R. C. 1984 . “An Experimental Investigation of the Vaporous/Gaseous Cavity Characteristics of an Eccentric Journal Bearing,” . ASLE Trans. , 27 ( 1 ) : 1 – 14 .
- Feng , N. S. and Hahn , E. J. 1985 . “Density and Viscosity Models for Two-Phase Homogeneous Hydrodynamic Damper Fluids,” . ASLE Trans. , 29 ( 3 ) : 361 – 369 .
- Diaz , S. E. and San Andres , L. 2001 . “A Model for Squeeze-film Dampers Operating with Air Entrainment and Validation with Experiments,” . J. Tribol. , 123 ( 1 ) : 125 – 133 .
- Nikolajsen , J. L. 1999 . “Viscosity and Density Models for Aerated Oil in Fluid-Film Bearings,” . Tribol. Trans. , 42 ( 1 ) : 186 – 191 .
- Diaz , S. E. and San Andres , L. 1998 . “Measurements of Pressure in a Squeeze-film Damper with an Air/Oil Bubbly Mixture,” . Tribol. Trans. , 41 ( 2 ) : 282 – 288 .
- Diaz , S. E. and San Andres , L. A. 1998 . “Reduction of the Dynamic Load Capacity in a Squeeze-film Damper Operating with a Bubbly Lubricant,” ASME Pap. 98-GT-109
- ESI Group . 2006 . CFD-ACE+ V2006 Modules Manual , Huntsville , AL : ESI CFD Inc. .
- Chen , P. Y. P. and Hahn , E. J. 2000 . “Side Clearance Effects on Squeeze-Film Damper Performance,” . Tribol. Int. , 33 ( 3-4 ) : 161 – 165 .
- Rabinowitz , M. D. and Hahn , E. J. 1977 . “Steady-State Performance of Squeeze-Film Damper Supported Flexible Rotors,” . J. Eng. Power Trans. ASME , 99 ( 4 ) : 552 – 558 .
- Dow Corning Corp . 2007 . “Dow Corning Material Data Sheet, Dow Corning 200 (R) Fluid, 10cSt,” MSDS No.: 01013190, p 5
- Dowson , D. and Taylor , C. M. 1979 . “Cavitation in Bearings,” . Ann. Rev. Fluid Mech. , 11 : 35 – 65 .
- Tao , L. , Diaz , S. , San Andres , L. and Rajagopal , K. R. 2000 . “Analysis of Squeeze-Film Dampers Operating with Bubbly Lubricants,” . J. Tribol. , 122 ( 1 ) : 205 – 210 .
- Gunter , E. J. , Barrett , L. E. and Allaire , P. E. 1977 . “Design of Nonlinear Squeeze-Film Dampers for Aircraft Engines,” . J. Lubric. Tech. , 99 ( 1 ) : 57 – 64 .