REFERENCES
- L. Z. Zhang and Y. Jiang , Heat and Mass Transfer in a Membrane-Based Enthalpy Recovery Ventilator , J. Membrane Sci. , vol. 163 , pp. 29 – 38 , 1999 .
- K. R. Kistler and E. L. Cussler , Membrane Modules for Building Ventilation , Chem. Eng Res. Design , vol. 80 , pp. 53 – 64 , 2002 . [CSA] [CROSSREF]
- L. Z. Zhang and J. L. Niu , Effectiveness Correlations for Heat and Moisture Transfer Processes in an Enthalpy Exchanger with Membrane Cores , ASME J. Heat Transfer , vol. 122 , pp. 922 – 929 , 2002 .
- K. Okada , M. Ono , T. Tomimara , T. Okuma , H. Konno , and S. Ohtani , Design and Heat Transfer Characteristics of New Plate Heat Exchanger , Heat Transfer—JpN. Res. , vol. 1 , pp. 90 – 95 , 1972 .
- W. W. Focke , J. Zachariades , and I. Olivier , The Effect of the Corrugation Inclination Angle on the Thermohydraulic Performance of Plate Heat Exchangers , Int. J. Heat Mass Transfer , vol. 28 , pp. 1469 – 1479 , 1985 . [CROSSREF]
- G. Gaiser and V. Kottke , Effects of Corrugation Parameters on Local and Integral Heat Transfer in Plate Heat Exchangers and Regenerators , Proc. 9th Int. Heat Transfer Conf. , Jerusalem , vol. 5 , pp. 85 – 90 , 1990 .
- M. Ciofalo , J. Stasiek , and M. W. Collins , Investigation of Flow and Heat Transfer in Corrugated Passages—2. Numerical Simulations , Int. J. Heat Mass Transfer , vol. 39 , pp. 165 – 192 , 1996 . [CSA] [CROSSREF]
- J. Stasiek , M. Ciofalo , I. K. Smith , and M. W. Collins , Investigation of Flow and Heat Transfer in Corrugated Passages—I. Experimental Results, Int. J. Heat Mass Transfer , vol. 39, no. 1, pp. 149–192, 1996. [CSA] [CROSSREF]
- A. Muley and R. M. Manglik , Enhanced Heat Transfer Characteristics of Single-Phase Flows in a Plate Heat Exchanger with Mixed Chevron Plates , J. Enhanced Heat Transfer , vol. 4 , pp. 187 – 201 , 1997 .
- S. Ergin , A. Ota , and H. Yamaguchi , Numerical Study of Periodic Turbulent Flow through a Corrugated Duct , Numer. Heat Transfer A , vol. 40 , pp. 139 – 156 , 2001 . [CSA] [CROSSREF]
- M. A. Mehrabian and R. Poulter , Hydrodynamics and Thermal Characteristics of Corrugated Channels: Computational Approach , Appl. Math. Modeling , vol. 24 , pp. 343 – 364 , 2000 . [CSA] [CROSSREF]
- H. Biomerius , C. Hoisken , and N. K. Mitra , Numerical Investigation of Flow Field and Heat Transfer in Cross-Corrugated Ducts , ASME J. Heat Transfer , vol. 121 , pp. 314 – 321 , 1999 . [CSA]
- K. Scott , A. J. Mahmood , R. J. Jachuck , and B. Hu , Intensified Membrane Filtration with Corrugated Membranes , J. Membrane Sci. , vol. 173 , pp. 1 – 16 , 2000 . [CROSSREF]
- D. W. Hall , K. Scott , and R. J. J. Jachuck , Determination of Mass Transfer Coefficient of a Cross-corrugated Membrane Reactor by the Limiting Current Technique , Int. J. Heat Mass Transfer , vol. 44 , pp. 2201 – 2207 , 2001 . [CSA] [CROSSREF]
- K. Scott and J. Lobato , Mass Transport in Cross-corrugated Membranes and the Influence of TiO2 for Separation Processes , Ind. Eng. Chem. Res. , vol. 42 , pp. 5697 – 5701 , 2003 . [CROSSREF]
- R. E. Spall , A. Richards , and D. M. McEligot , An Assessment of k–Omega and v(2)–f Turbulence models for Strongly Heated Internal Gas Flows , Numer. Heat Transfer A , vol. 46 , pp. 831 – 849 , 2004 . [CROSSREF]
- V. K. Garg and A. A. Ameri , Comparison of Two-Equation Turbulence Models for Prediction of Heat Transfer on Film-Cooled Turbine Blades , Numer. Heat Transfer A , vol. 32 , pp. 347 – 371 , 1997 .
- R. M. Jones , A. D. Harvey , and S. Acharya , Two Equation Turbulence Modeling for Impeller Stirred Tanks , ASME J. Fluids Eng. , vol. 123 , pp. 640 – 648 , 2001 . [CSA]
- B. Song and R. S. Amano , Application of Non-Linear k − ϵ Model to a Turbulent Flow inside a Sharp U-bend , Comput. Mech. , vol. 26 , pp. 344 – 351 , 2000 . [CROSSREF]
- C. V. Patel , W. Rodi , and G. Scheuerer , Turbulence Models for Near Wall and Low Reynolds Number Flows: A Review , AIAA J. , vol. 23 , pp. 1308 – 1319 , 1984 .