References
- S. Roundy and P. K. Wright, A piezoelectric vibration based generator for wireless electronics, Smart Mater. Struct. 13 (5), 1131 (2004). DOI: 10.1088/0964-1726/13/5/018.
- H. I. Jun et al., Generating characteristics of a cross-shaped piezoelectric energy harvester, Ferroelectrics 466 (1), 92 (2014). DOI: 10.1080/00150193.2014.895169.
- H. J. Jung et al., Design of a new piezoelectric energy harvester based on secondary impact, Ferroelectrics 449 (1), 83 (2013). DOI: 10.1080/00150193.2013.822773.
- V. Shah et al., Piezoelectric materials for bistable energy harvester: A comparative study, Integr. Ferroelectr. 176 (1), 73 (2016). DOI: 10.1080/10584587.2016.1248750.
- Y. Wang, C. Luo, and P. Li, Linear multi-degree-of-freedom low-frequency piezoelectric vibration energy harvester, Ferroelectrics 502 (1), 57 (2016). DOI: 10.1080/00150193.2016.1233029.
- H. F. Zhang, P. Lee, and J. A. Kosinski, Experimental study of a frequency-adjustable piezoelectric bimorph energy harvester, Ferroelectrics 437 (1), 36 (2012). DOI: 10.1080/00150193.2012.743409.
- H. Huang et al., Elastic and electric damping effects on piezoelectric cantilever energy harvesting, Ferroelectrics 459 (1), 1 (2014). DOI: 10.1080/00150193.2013.837735.
- Q. Hua-Cheng et al., Resonance-mode effect on piezoelectric micro cantilever performance in air, with a focus on the torsional modes, Chinese Phys. B. 23 (2), 027701 (2014). DOI: 10.1088/1674-1056/23/2/027701.
- J. W. Yi, W. Y. Shih, and W. H. Shih, Effect of length, width, and mode on the mass detection sensitivity of piezoelectric unimorph cantilevers, J. Appl. Phys. 91 (3), 1680 (2002). DOI: 10.1063/1.1427403.
- S. Saadon and O. Sidek, Micro-electro-mechanical system (MEMS)-based piezoelectric energy harvester for ambient vibrations, Proc. Soc. Behav. Sci. 195, 2353 (2015). DOI: 10.1016/j.sbspro.2015.06.198.
- J. H. Lin et al., Modeling and simulation of piezoelectric MEMS energy harvesting device, Integr. Ferroelectr. 95 (1), 128 (2007). DOI: 10.1080/10584580701756649.
- L. Dhakar et al., A new energy harvester design for high power output at low frequencies, Sens. Actuators, A 199, 344 (2013). DOI: 10.1016/j.sna.2013.06.009.
- M. A. Halim and J. Y. Park, Theoretical modelling and analysis of mechanical impact driven and frequency up-converted piezoelectric energy harvester for low frequency and wide-bandwidth operation, Sens. Actuators, A 208, 56 (2014). DOI: 10.1016/j.sna.2013.12.033.
- S. Yu, S. He, and W. Li, Theoretical and experimental studies of beam bimorph piezoelectric power harvesters, JoMMS 5 (3), 427 (2010). DOI: 10.2140/jomms.2010.5.427.
- N. E. Dutoit, B. L. Wardle, and S. G. Kim, Design considerations for MEMS-scale piezoelectric mechanical vibration energy harvesters, Integr. Ferroelectr. 71 (1), 121 (2005). DOI: 10.1080/10584580590964574.
- W. J. Choi et al., Energy harvesting MEMS device based on thin film piezoelectric cantilevers, J. Electroceram. 17 (2–4), 543 (2006). DOI: 10.1007/s10832-006-6287-3.
- S.-B. Kim et al., Comparison of mems pzt cantilevers based on d31g and d33g modes for vibration energy harvesting, J. Microelectromech. Syst. 22 (1), 26 (2013). DOI: 10.1109/JMEMS.2012.2213069.
- B. Ren et al., Piezoelectric energy harvesting based on shear mode 0.71 Pb (Mg1/3Nb2/3)O3-0.29 PbTiO3 single crystals, IEEE Trans. Ultrason, Ferroelect, Freq. Control. 57 (6), 1419 (2010).
- A. Delnavaz and J. Voix, Energy harvesting for in-ear devices using ear canal dynamic motion, IEEE Trans. Ind. Electron. 61 (1), 583 (2014). DOI: 10.1109/TIE.2013.2242656.
- Z. L. Wang and J. Song, Piezoelectric nanogenerators based on zinc oxide nanowire arrays, Science 312 (5771), 242 (2006). DOI: 10.1126/science.1124005.
- Y. Zhou, D. J. Apo, and S. Priya, Dual-phase self-biased magnetoelectric energy harvester, Appl. Phys. Lett. 103 (19), 192909 (2013). DOI: 10.1063/1.4829151.
- M. Defosseux et al., Highly efficient piezoelectric micro harvester for low level of acceleration fabricated with a cmos compatible process, Sens. Actuators, A 188, 489 (2012). DOI: 10.1016/j.sna.2012.07.002.