References
- H. Hirani, K. Athre and S. Biswas. ‘Rapid and globally convergent method for dynamically loaded journal bearing design’, Proc. Inst. Mech. Eng., Part J: J. Eng. Tribol., 1998, 212, 207–214.10.1243/1350650981542010
- H. Hirani, K. Athre and S. Biswas. ‘Dynamic analysis of engine bearings’, Int. J. Rotating Mach., 1999, 5, 283–293.10.1155/S1023621X99000251
- H. Hirani, K. Athre and S. Biswas. ‘A hybrid solution scheme for performance evaluation of crankshaft bearings’, Trans. ASME, J. Tribol., 2000, 122, 733–740.10.1115/1.1286271
- S. M. Muzakkir, H. Hirani, G. D. Thakre and M. R. Tyagi. ‘Tribological failure analysis of journal bearings used in sugar mills’, Eng. Fail. Anal., 2011, 18, 2093–2103.10.1016/j.engfailanal.2011.06.016
- S. Singhal. ‘Sleeve bearing design for slow speed applications’, Tech. Conf. Rec. IEEE., 2008, 283–290.
- K. F. Dufrane and J. W. Kannel. ‘Wear of steam turbine journal bearings at low operating speeds’, J. Lubr. Technol., 1983, 105, 313–317.10.1115/1.3254599
- S. Gwidon and A.W. Batchelor. ‘Engineering Tribology’, Butterworth-Heinemann, 2011, 282–283
- K. P. Lijesh, H. and Hirani. ‘Optimization of eight pole radial active magnetic bearing’, J. Tribol., 2015, 137, 024502-1–024502-7.10.1115/1.4029073
- H. Hirani and P. Samanta. ‘Hybrid (hydrodynamic + permanent magnetic) journal bearings’, Proc. Inst. Mech. Eng., Part J: J. Eng. Tribol., 2007, 221, 881–891.
- K. P. Lijesh and H. Hirani. ‘Stiffness and damping coefficients for rubber mounted hybrid bearing’, Lubr. Sci., 2014, 26, 301–314.
- S. M. Muzakkir, H. Hirani and G. D. Thakre. ‘Lubricant for heavily-loaded slow speed journal bearing’, Tribol. Trans., 2013, 56, 1060–1068.10.1080/10402004.2013.823530
- M. A. Omer, T. V. V. L. N Rao, A. M. A. Rani, T. Nagarajan and F. M. Hashim. ‘Pressure distribution in hydrodynamic journal bearing with lubricants additives’, in ‘ MATEC Web of Conferences’, 2014, 13, 05006-p.1–05006-p.3.
- A. K. Kohli and B. Prakash. ‘Contact pressure dependency in frictional behavior of burnished molybdenum disulphide coatings’, Tribol Trans., 2001, 44, 147–151.10.1080/10402000108982439
- Y. R. Jeng, Y. H. Huang, P. C. Tsai and G. L. Hwang. ‘Tribological properties of carbon nanocapsule particles as lubricant additive’, J. Tribol., 2014, 136, 0418011–0418019.
- Peng Y. and Ni Z. ‘Tribological properties of stearic acid modified multi-walled carbon nanotubes in water’, J. Tribol., 2013, 135, 012001-1–012001-5.
- Cumings J. and Zettl A. ‘Low-friction nanoscale linear bearing realized from multiwall carbon nanotubes’, Sci., 2000, 289, 602–604.10.1126/science.289.5479.602
- C. S. Chen, X. H. Chen, L. S. Xu, Z. Yang and W. H. Li. ‘Modification of multi-walled carbon nanotubes with fatty acid and their tribological properties as lubricant additive’, Carbon, 2005, 43, 1660–1666.10.1016/j.carbon.2005.01.044
- C. S. Chen, X. S. Chen, H. U. Jing, H. Zhang, W. H. Li, L. S. Xu and Yang Z. ‘Effect of multi walled carbon nanotubes on tribological property of lubricant’, Trans. Nonferrous Met. Soc. China., 2005, 15, 300–305.
- A. Garg and S. B. Sinnott. ‘Effect of chemical functionalization on the mechanical properties of carbon nanotubes’, Chem. Phys. Lett., 1998, 295, 273–278.10.1016/S0009-2614(98)00969-5
- R. Rastogi, R. Kaushal, S. K. Tripathi, A. L. Sharma, I. Kaur and L. M. Bharadwaj. ‘Comparative study of carbon nanotube dispersion using surfactants’, J. Colloid Interface Sci., 2008, 328, 421–428.10.1016/j.jcis.2008.09.015
- K. P. Lijesh, S. M. Muzakkir and H. Hirani. ‘Experimental tribological performance evaluation of nano lubricant using multi-walled carbon nano-tubes (MWCNT)’, Int. J. Appl. Eng. Res., 2015, 10, 14543–14550.
- H. Cai, F. Yan and Q. Xue. ‘Investigation of tribological properties of polyimide/carbon nanotube nanocomposites’, Mater. Sci. Eng.: A, 2004, 364, 94–100.10.1016/S0921-5093(03)00669-5
- S. M. Muzakkir, K. P. Lijesh, H. Hirani and G. D. Thakre. ‘Effect of cylindricity on the tribological performance of the heavily loaded slow speed journal bearing,’ J. Eng. Tribol., 2014, 229, 178–195.
- C. S. Chen, X. H. Chen, L. S. Xu, Z. Yang and W. H. Li. ‘Modification of multi-walled carbon nanotubes with fatty acid and their tribological properties as lubricant additive’, Carbon, 2005, 43, 1660–1666.10.1016/j.carbon.2005.01.044