http://orcid.org/0000-0002-6721-1430
References
- Her MG, Weng FT, et al. Micro-hole machining of copper using the electro-discharge machining process with a tungsten carbide electrode compared with a copper electrode. Int J Adv Manuf Technol. 2001;17(10):715–719.
- Kadirvel A, Hariharan P, Gowri S, et al. Experimental investigation on the electrode specific performance in micro-EDM of die-steel. Mater Manuf Processes. 2013;28(4):390–396.
- Singh S, Maheshwari S, Pandey PC, et al. Some investigations into the electric discharge machining of hardened tool steel using different electrode materials. J Mater Process Technol. 2004;149(1):272–277.
- Leera R, Sanghvi SV, Hiremath SS, Singaperumal M, et al. Effect of process parameters on quality of micro holes machined on copper plate using developed μ-EDM setup. Appl Mech Mater. 2014;592:229–233.
- Maity KP, Singh RK. An optimisation of micro-EDM operation for fabrication of microhole. Int J Adv Manuf Technol. 2012:1221–1229.10.1007/s00170-012-4098-z
- Meena VK, Azad MS, et al. Grey relational analysis of micro-EDM machining of Ti-6Al-4 V alloy. Mater Manuf Processes. 2012;27(9):973–977.
- Tiwary AP, Pradhan BB, Bhattacharyya B, et al. Study on the influence of micro-EDM process parameters during machining of Ti–6Al–4 V super alloy. Int J Adv Manuf Technol. 2015:76(1–4):151–160.
- Jothimurugan R, Amrithagadeswaran KS, Daniel J, et al. Performance of silver coated copper tool with kerosene- servotherm dielectric in MEDM of Monel 400TM. J Appl Sci. 2012;12:999–1005.
- Deng J. Introduction to grey system. J Grey Syst. 1989;1:1–24.
- Fei NC, Mehat NM, Kamaruddin S, et al. Review article: practical applications of taguchi method for optimization of processing parameters for plastic injection moulding: a retrospective review. ISRN Ind Eng. 2013; 1–11.