References
- T. Senuma: ‘Physical metallurgy of modern high strength steel sheets’, ISIJ Int., 2001, 41, 520–532.
- Y. Z. Liu, J. H. Sun, L. Y. Zhou, Y. G. Tu, F. Xing, Y. C. Guo and Q. Tong: ‘Experiment investigation of deep-drawing sheet texture evolution’, Mater. Process. Technol., 2003, 140, 509–513.
- N. Peranio, Y. J. Li, F. Roters and D. Raabe: ‘Microstructure and texture evolution in dual-phase steels: competition between recovery, recrystallization, and phase transformation’, Mater. Sci. Eng. A, 2010, 527, 4161–4168.
- M. Sarwar, E. Ahmad, K. A. Qureshi and T. Manzoor: ‘Influence of epitaxial ferrite on tensile properties of dual phase steel’, Mater. Des., 2007, 28, 335–340.
- H. Hu: ‘Studies on the development of high-strength dual-phase steel sheets with high rm values’, Metall. Trans. A, 1982, 13, 1257–1262.
- H. Yoshida, K. Okuda, H. Kawabe, T. Urabe, Y. Tanaka and Y. Hosoya: ‘Effect of niobium addition on the texture formation of high strength cold-rolled low carbon steel sheets’, Mater. Sci. Forum, 2007, 558–559, 425–430.
- S. G. Chowdhury, E. V. Pereloma and D. B. Santos: ‘Evolution of texture at the initial stages of continuous annealing of cold rolled dual-phase steel: effect of heating rate’, Mater. Sci. Eng. A, 2008, 480, 540–548.
- S. J. Kim, Y. G. Cho, C. S. Oh, D. E. Kim, M. B. Moon and H. N. Han: ‘Development of a dual phase steel using orthogonal design method’, Mater. Des., 2009, 30, 1251–1257.
- J. Y. Kang, B. Bacroix, H. Regle, K. H. Oh and H. C. Lee: ‘Effect of deformation mode and grain orientation on misorientation development in a body-centered cubic steel’, Acta Mater., 2007, 55, (15), 4935–4946.
- G. Erdema and Y. Taptik: ‘Effect of hot rolling conditions to produce deep drawing quality steels for continuous annealing process’, J. Mater. Process. Technol., 2005, 170, 17–23.
- S. H. Han, S. H. Choi, J. K. Choi, H. G. Seong and I. B. Kim: ‘Effect of hot-rolling processing on texture and r value of annealed dual-phase steels’, Mater. Sci. Eng. A, 2010, 527, 1686–1694.
- J. Y. Kang, H. C. Lee and S. H. Han: ‘Effect of Al and Mo on the textures and microstructures of dual phase steels’, Mater. Sci. Eng. A, 2011, 530, 183–190.
- H. Inagaki: ‘Fundamental aspect of texture formation in low carbon steel’, ISIJ Int., 1994, 4, 313–321.
- R. K. Ray, J. J. Jonas, M. P. Butron and J. Savoie: ‘Transformation textures in steels’, ISIJ Int., 1994, 34, 12, 927–942.
- X. Chen and R. Sowerby: ‘Blank development and the prediction of earing in cup drawing’, Int. J. Mech. Sci., 1996, 38, 509–516.