References
- H. Krapfenbauer: ‘New aspects for the mass production of spur gears by cold rolling’, IPE Int. Ind. Prod. Eng., 1984, 8, (3), 39–41.
- N. Kurz: ‘Theoretical and experimental investigations of the ‘Grob’ cold shape-rolling process’, Proc. Int. Machine Tool Design and Research Conf. 25th, UK, 1985, 551–559.
- Z. L. Kahn-Jetter and W. Suzanne: ‘Finite element analysis of an involute spline’, J. Mech. Des., 2000, 122, (2), 239–244.
- K. T. Cui: ‘Finite element analysis and elastic-plasticity correction of rolling splines’, Master's thesis, Henan University of Science and Technology, CHN, 2008.
- Y. F. Xu: ‘Dynamics analysis and simulation of cold rolling spline’, Master's thesis, Henan University of Science and Technology, CHN, 2008.
- J. H. Quan: ‘Study on forming mechanism of involute spline shaft's cold rolling based on ANSYS-DYNA’, Master's thesis, Henan University of Science and Technology, CHN, 2007.
- C. Cho, and Y. J. Kim: ‘Study on forming condition and tool of flywheel by using flow forming process’, Mater. Res. Innov. Korea, 2011, 15, (Suppl. 1), S336–S339.
- F. K. Cui: ‘Study of high-speed precise forming with cold roll-beating technique’, PhD thesis, Xi'an University of Technology, CHN, 2007.
- S. Y. Xiao and H. H. Pan: ‘Rate dependent plastic-damage constitutive model of concrete’, Mater. Res. Innov., Chin., 2011, 15, (Suppl. 1), S81–S84.
- Q. M. Guo, D. F. Li and S. L. Guo: ‘Microstructural models of dynamic recrystallization in hot-deformed inconel 625 superalloy’, Mater. Manuf. Process., 2012, 27, (9), 990–995.