References
- A. Azushima, K. Uda and A. Yanagida: ‘Friction behavior of aluminum-coated 22MnB5 in hot stamping under dry and lubricated conditions’, J. Mater. Process. Technol., 2012, 212, (5), 1014–1021.
- A. Yanagida, T. Kurihara and A. Azushima: ‘Development of tribo-simulator for hot stamping’, J. Mater. Process. Technol., 2010, 210, (3), 456–460.
- S. Hyunwoo, F. Dennis, H. Hartmut, G. Roland and S. Mirko: ‘An investigation of the blanking process of the quenchable boron alloyed steel 22MnB5 before and after hot stamping process’, J. Mater. Process. Technol., 2012, 212, (2), 437–449.
- K. Mori: ‘Smart hot stamping of ultra-high strength steel parts’, Trans. Nonferrous Met. Soc. China, 2012, 22, (S2), s496–s503.
- H. Karbasianm and A. E. Tekkaya: ‘A review on hot stamping’, J. Mater. Process. Technol., 2010, 210, (15), 2103–2118. .
- M. Naderi, M. Ketabchi, M. Abbasi and W. Bleck: ‘Analysis of microstructure and mechanical properties of different boron and non-boron alloyed steels after being hot stamped’, Proc. Eng., 2011, 10, 460–465.
- M. Nikravesh, M. Naderi and G. H. Akbari: ‘Influence of hot plastic deformation and cooling rate on martensite and bainite start temperatures in 22MnB5 steel’, Mater. Sci. Eng. A, 2012, 540, 24–29.
- C. Junye, Z. Aimin, C. Yinli, D. Rui and H. Yao: ‘EBSD studies of 30MnB5 hot stamping steel tempered at different temperature’, Acta. Metall. Sin., 2013, 49, (2), 137–145.
- M. Merklein and T. Svec: ‘Hot stamping: manufacturing functional optimized components’, Prod. Eng. Dev., 2012, 11, 1–11.
- A. Yanagida, T. Kurihara and A. Azushima: ‘Development of tribo-simulator for hot stamping’, J. Mater. Process. Technol., 2010, 210, (3), 456–460.