10
Views
1
CrossRef citations to date
0
Altmetric
Technical Paper

A Theoretical Critical Heat Flux Model for Low-Pressure, Low-Mass-Flux, and Low-Steam-Quality Conditions

, , &
Pages 332-345 | Published online: 10 May 2017

References

  • R. HINO and T. UEDA, “Studies on Heat Transfer and Flow Characteristics in Subcooled Flow Boiling—Part 2, Flow Characteristics,” Int. J. Multiphase Flow, 11, 3, 283 (1985).
  • S. B. V. MOLEN and F. B. W. M. GALJEE, “The Boiling Mechanisms During Burnout Phenomena in Subcooled Two-Phase Water Flow,” Proc. 6th Int. Heat Transfer Conf., Toronto, Canada, August 7–11, 1978, Vol. 1, p. 381 (1978).
  • C. H. LEE and I. MUDAWWAR, “A Mechanistic Critical Heat Flux Model for Subcooled Flow Boiling Based on Local Bulk Flow Conditions,” Int. J. Multiphase Flow, 14, 6, 711 (1988).
  • W. S. LIN, C. H. LEE, and B. S. PEI, “An Improved Theoretical Critical Heat Flux Model for Low-Quality Flow,” Nucl. Technol., 88, 294 (1989).
  • C. H. LEE and C. J. CHANG, “Modelling of Critical Heat Flux for Subcooled and Low Quality Flow Boiling,” presented at Winter Annual Mtg. American Society of Mechanical Engineers, San Francisco, California, December 10–15, 1989, paper 89-WA/NE-2 (1989).
  • L. BIASI et al., “Studies on Burnout, Part 3. A New Correlation for Round Ducts and Uniform Heating and Its Comparison with World Data,” Energia Nucl., 14, 9, 530 (1967).
  • D. C. GROENEVELD, S. C. CHENG, and T. DOAN, “1986 AECL-UO Critical Heat Flux Lookup Table,” Heat Transfer Eng., 7, 1-2, 46 (1986).
  • P. WEBER and K. JOHANNSEN, “Convection Transition Boiling of Water at Medium Pressure,” Proc. 9th Int. Heat Transfer Conf., Jerusalem, Israel, August 19–24, 1990, Vol. 6 (1990).
  • “Heat Mass Transfer Section, Scientific Council, Academy of Science, USSR, Tabular Data for Calculating Burnout When Boiling Water in Uniformly Heated Round Tubes,” Thermal Eng., 23, 9, 77 (1972).
  • S. C. CHENG, H. RAGHEB, W. W. L. NG, K. T. HENG, and S. ROY, “Transition Boiling Heat Transfer in Forced Vertical Flow,” NUREG/CR-0357, ANL-78-75, Argonne National Laboratory (1978).
  • S. C. CHENG, W. W. L. NG, and K. T. HENG, “Transition Boiling Heat Transfer in Forced Vertical Flow,” Quarterly Report No. 2, University of Ottawa (1976).
  • S. C. CHENG, W. W. L. NG. K. T. POON, and M. B. ELGHOBARY, “Transition Boiling Heat Transfer in Forced Vertical Flow,” Quarterly Report No. 14, University of Ottawa (1979).
  • K. M. BECKER, G. HERNBORG, M. BODE, and Ο. ERIKSSON, “Burnout Data for Flow of Boiling Water in Vertical Round Ducts, Annuli and Rod Clusters,” AE-177, Heat Engineering Laboratory, AB Atomenergi (1965).
  • E. BURCK and W. HUFSCHMIDT, “Messung der Kritischen war mestromdichte von Wasser im Unterk unlten Zustand in Rohren bei Erzwungener Strömung,” Europische Atomgemeinschaft-Euratom (1965).
  • B. THOMPSON and R. V. MACBETH, “Boiling Water Heat Transfer and Burnout in Uniformly Heated Round Tubes: A Compilation of World Data with Accurate Correlations,” AEEW R-356, United Kingdom Atomic Energy Authority (1964).
  • M. P. FIORI and A. E. BERGLES, “Model of Critical Heat Flux in Subcooled Flow Boiling,” Proc. 4th Int. Heat Transfer Conf., Paris, France, August 31–September 5, 1970, Vol. 6, paper b6.3, Elsevier, Amsterdam (1970).
  • J. S. KIRBY, R. STANIFORTH, and J. H. KINNEIR, “A Visual Study of Forced Convection Boiling: Part 2, Flow Patterns and Burnout for a Round Test Section,” AEEW-R506, United Kingdom Atomic Energy Authority (1967).
  • P. WEBER and K. JOHANNSEN, “Study of the Critical Heat Flux Condition at Convective Boiling of Water: Temperature and Power Controlled Experiments,” Proc. 9th Int. Heat Transfer Conf., Jerusalem, Israel, August 19–24, 1990, Vol. 1 (1990).
  • P. WEBER, “Experimentelle Untersuchungen zur Siedekrise und zum Obergangssieden von Strömendem Wasser Untererhohtem Druck,” PhD Thesis, University of Berlin (1990) (in German).
  • J. WEISMAN, “The Current Status of Theoretically Based Approaches to the Prediction of the Critical Heat Flux in Flow foiling,’” Nucl. Technol., 9, 1 (1992).
  • J. WEISMAN and B. S. PEI, “Prediction of Critical Heat Flux in Flow Boiling at Low Qualities,” Int. J. Heat Mass Transfer, 26, 1463 (1983).
  • Y. HARAMURA and Y. KATTO, “A New Hydrodynamic Model of Critical Heat Flux, Applicable Widely to Both Pool and Forced Convection BoiUng Submerged Bodies in Saturated Liquids,” Int. J. Heat Mass Transfer, 26, 389 (1983).
  • L. S. TONG, “Prediction of Departure from Nucleate Boiling for an Axially Non-Uniform Heat Flux Distribution,” J. Nucl. Energy, 21, 241 (1967).
  • Y. KATTO, “A Physical Approach to Critical Heat Flux of Subcooled Flow Boiling in Round Tubes,” Int. J. Heat Mass Transfer, 33, 4, 611 (1990).
  • R. F. GAERTNER and J. W. WESTWATER, “Population of Active Sites in Nucleate Boiling Heat Transfer,” Chem. Eng. Prog. Symp. Ser., 56, 39 (1960).
  • K. CORNWELL and L. S. LEONG, “On the Analysis of Low Quality Flow Boiling,” Int. J. Heat Fluid Flow, 2, 63 (1979).
  • N. ZUBER and J. FINDLAY, “Average Volumetric Concentration in Two-Phase Flow Systems,” Trans. ASME J. Heat Transfer, 87, 453 (1965).
  • P. SAHA and N. ZUBER, “Point of Net Vapor Generation and Vapor Void Fraction in Subcooled Boiling,” Proc. 5th Int. Heat Transfer Conf., Tokyo, Japan, September 3–7, 1974, paper B4.
  • R. COLE and W. R. ROHSENOW, “Correlation of Bubble Departure Diameter for Boiling of Saturated Liquids,” Chem. Eng. Prog. Symp., 92, 211 (1968).
  • T. E. HARMATHY, “Velocity of Large Drops and Bubbles in Media of Infinite and Restricted Extent,” AIChE J., 6, 281 (1960).
  • J. G. COLLIER, Convective Boiling and Condensation, 2nd ed., p. 269, McGraw-Hill Book Company, London (1980).
  • I. P. SMOGALEV, “Calculation of Critical Heat Fluxes with Flow of Subcooled Water at Low Velocity,” Thermal Eng., 28, 208 (1981).

Reprints and Corporate Permissions

Please note: Selecting permissions does not provide access to the full text of the article, please see our help page How do I view content?

To request a reprint or corporate permissions for this article, please click on the relevant link below:

Academic Permissions

Please note: Selecting permissions does not provide access to the full text of the article, please see our help page How do I view content?

Obtain permissions instantly via Rightslink by clicking on the button below:

If you are unable to obtain permissions via Rightslink, please complete and submit this Permissions form. For more information, please visit our Permissions help page.